1. Home
  2. Login
  3. Recent Orders
  4. View Cart
  5. Checkout

Electronize FF40HX-AN 40amp Forwards Only Electronic Speed Controller

Part No:
FF40HX-AN

Price: 45.60 (Including VAT at 20%)
Euros: 50.16(Inc VAT) / US Dollars: US$48.64(Tax Free)

Electronize FF40HX 40amp Electronic Speed Controller Forwards Only
Auto Neutral No BEC

Electronize FF40HX 40amp Electronic Speed Controller Forwards Only
Auto Neutral No BEC
The FF40HX is derived from our FR30HX microprocessor based speed controller. It has all the features of the FR30HX except reverse, the motor runs forward for both directions of the stick.

The controller is intended for Jet Drives and other fast boats and has an increased continuous rating of 40 amp.

The FF40HX has a selectable operating mode, giving a choice of high, low or variable frequency. Operating at low frequency gives better starting and low speed control, whereas high frequency gives smoother and more efficient high speed performance. The unique Electronize variable frequency mode gives the best of both worlds. It's a best performance low frequency controller, a smooth mid-range controller and an efficient high frequency controller all at the same time.

As has come to be expected from all Electronize controllers, the FF40HX gives the very best speed control over the full range from idle to full speed. With this new design we have taken our high standard a step further. Firstly, the microprocessor digitally measures the input signal and totally rejects any out of limits signal produced by interference. Next the 'good' signals are used to calculate a rolling average for the transmitter signal. Slight interference causes the jitter that makes most controllers seem harsh. Using this digital technique, interference effects are reduced by a factor of 8 whilst maintaining a fast response time of only 160 milli-seconds.
With this speed controller there is no complicated set up sequence, as found on many microprocessor based units. The neutral position is pre-set with a precision within 0.5%. A simple screwdriver adjustment sets the speed range from 25 to 125%.
The electronic controller plugs directly into the 'throttle' output of the receiver with no need for a servo. There is no need to match the electronic control to the motor other than to stay within the maximum ratings. The same control will work equally well with a large or small motor.

Features
Standard radio control servo signal input. (standard connector supplied)
Smooth P.W.M. forward speed control for both directions of the transmitter stick.
Selectable operating mode.
Low frequency mode: 100Hz
Variable frequency mode: 10 to 1000Hz
High frequency mode: 2000Hz
Low loss Power MOSFET current switching. (Only 2.7 milli-Ohms)
Low loss heavy duty cables. (0.25mm2)
Precision pre-set neutral.
Adjustable speed range to match throttle stick travel or scale speed.
6 to 24 volt motor battery operation. (5.5 volt min.)
40 amp. continuous load rating.
90 amp. short term stall rating. (continuous MOSFET rating)*
540 amp. peak rating.

Recently Viewed